INSTRUCTIONS

The Whizzinator is very simple. It is essential, however, that you have a complete understanding of its operation. Please read these instructions very carefully and then PRACTICE!

Put about 80 cc. of urine into a cup. Draw half up at a time into the syringe and inject it into the bag through the small tube with the screw-on cap. Make sure that the end of the syringe is tight into the tube so that there will not be any leakage. Also, be sure the clip valve (located in the center of the belt, above the prosthesis) is shut. Do not put more than 80 cc. of liquid into the bag. Remove as much air from the bag as possible. When the belt and the bag are worn, it is important that the vinyl bag makes contact with your bare skin in order to absorb body temperature. Your natural body temperature will heat the urine to approximately 92 degrees. It will take about one hour to raise it from room temperature. The heat packs are a supplementary heat source. One heat pack will bring the urine up to 98-100 degrees and will maintain that temperature for at least eight hours. Please note, if you are using the concentrated urine and need the liquid warm quickly, start with warm (100 degrees) water and then mix the concentrate with the water. Open up one heat pack. Apply it to the side of the bag opposite the temperature strip. This locates the heat pack on the side of the bag away from your body. It is important. The LCD temperature strip on the vinyl bag will read two degrees warmer than the actual fluid temperature.

TIP - Peel off only one-half of the backing covering the adhesive on the back of the heat pack. Half the adhesive holds the pack securely and is much easier to remove later. Remember to remove the heat pack after you finish using it. If the adhesive dries for too long, the heat packs are difficult to remove.

As you can see, the elastic straps are adjustable. Any excess length can be taken up by going once around the belt before fastening. Try positioning the belt so that the end of the prosthesis hangs to the end of your own penis. That will make it much easier to find. Our clip valve, which releases the urine can make a slight snap sound when it is opened. Try disguising the sound by clearing your throat or coughing as you open it. To operate The Whizzinator, hold the prosthesis with one hand and pinch it just behind the head to prevent any flow as you open the clip valve with your other hand. Then, take the sample cup, relax the pinch and Whiz. This operation will approximate the natural way that you would urinate into a cup. Remember, practice makes perfect. Using plain water, practice as much as possible. Again, if you use the concentrated urine, mix it with 80 cc. of warm water. It will last in its concentrated state indefinitely, but once it is mixed, it should be used within eight hours. As with real urine, it will begin to grow bacteria after eight hours. The Whizzinator should be cleaned by flushing the vinyl bag out with warm water after each usage. Use the syringe to fill the bag and drain it through the prosthesis several times. Do not use soap to clean the inside of the bag. Good Luck! Give us a call if you have any questions!!

GUARANTEE

Due to the nature of the product, if it has been used in any way misused, there will be no refund. If any of the components of The Whizzinator fail within 30 days, under normal use, the purchaser will be entitled to an exchange of the defective parts. Exchanges can only be made with proof of purchase and must be sent to the address below.

 

WE RECOMMEND DEHYDRATED URINE IF FULL SPECTRUM URINE TESTING METHODS ARE EMPLOYED.

NOTE: Our supplier highly recommend the use of a urine heating device which will ensure that the urine is delivered at the proper temperature. Temperature of the urine specimen is routinely checked and a cold specimen is grounds for a retest.

The above information has been provided by the manufacturer of our synthetic urine. If you should require any further information, please feel free to call us at any time.